 |
|
Shure PSM 200 In-Ear Monitor System
Take it from a musician ... once you have experienced the clarity and control of an in-ear personal monitor system, you will never go back to bulky feedback-prone floor wedges again! If you know your equipment, you also know that Shure is one of the best brand names in pro audio equipment. |
| This is a brand new factory sealed Shure PSM
200 monitor system with complete manufacturers warranty. Here are the specs:
|
|
The P2TRE2 wireless personal monitor system with mix control consists of the P2T Wireless Transmixer, the P2R Hybrid Bodypack Reciever, and the E2 Dynamic Driver Earphones.
|
| P2T Wireless TransMixer |
| The P2T TransMixer is breakthrough design for in-ear monitoring. It allows the user to connect two line-level or miclevel inputs directly into the transmitter. The two signals can then be mixed independently. You can connect microphones or instruments directly to the inputs, use line outputs from a mixing console, or connect it to Shure's AuxPander. In short, no matter what the output device, you can probably plug it into the TransMixer. |
| Key Features |
| Built-in audio limiter
|
| Front mounted antenna
|
| Two mic/line input channels for mix control
|
| 1/2 Rack space |
| Operating Controls |
| Input level control
|
| Frequency select |
| LED Indicators |
| Tri-color input level
|
| Frequency |
| Inputs |
| Two Mic/line, XLR-1/4 in. combo input channels |
| Outputs |
| Two XLR split outputs |
| P2R Hybrid Bodypack Receiver |
| The P2R Receiver is the world's first bodypack receiver to function as a wired receiver, a wireless receiver, or both at the same time. This and other unique features, along with excellent sound quality, make the P2R an exceptional value.
|
| Key Features |
| Can operate as a wired or wireless bodypack, or both simulaneously
|
| Frequency locator
|
| Built-in headphone limiter
|
| Integrated cable management
|
| High-impact plastic chassis
|
| 1/4" Line inpit jack with high/low gain switch |
| Operating Controls |
| Volume knob
|
| Frequency select |
| LED Indicators |
| Power
|
| RF reception
|
| Frequency
|
| Limiter
|
| Low Battery |
| E2 Dynamic Driver Earphones |
| Single high energy drivers deliver full range sound and isolation from outside noise. |
| Specifications |
| Transducer Type: dynamic high energy
|
| Sensitivity (at 1 kHz): 105 dB SPL/mW
|
| Impedance (at 1 kHz) 16 ohms
|
| Output Connector: Gold-plated stereo, 3.5 mm (1/8-inch) phone plug
|
| Cable Length: 1.57 m (62 inches) |
|
Technical specs and user manual can be viewed at: http://www.shure.com/psm/models/p2tre2.asp
|
